Manrose CF200

The CF200 range incorporates the latest technology and design in a powerful but very quiet centrifugal fan. This new range is fitted with a backward curved centrifugal impeller for a large airflow against the high pressures caused by longer lengths of ducting and resistance by grilles. Ideally suited for common or flat duct installations.

Features include:

• Extract rate 110m³hr, 31 litres per second
  
• 2 Speed humidistat model standard
  
• Fans can be wall or ceiling mounted
  
• CF200 available in eight options. S.E.L.V. option also available
  
• British made
  
• Designed to exceed the 1995 Building Regulations on Ventilation (F1)
  
• Fitted with a built-in spring operated non return flap into the discharge spigot to prevent backdraughts
  
• 2 year no quibble guarantee
  
• Designed to comply with HD280/BS3456 Part 102:342 1988
  
• BEAB Approved
  
• Rated to IP44

Technical Data

Catalogue No. Type
CF200S Standard model for remote switching.
CF200P As above supplied with pullcord switch.
CF200T Timer model incorporating integral adjustable electronic timer (adjustable 1-20 mins).
CF200TP As above but with pullcord override switch. Requires no switched live.
CF200H Humidity control fitted with our new 2 speed option as standard. The fan will run at full speed on integral or remote switching but will run at about half speed when humidity rises over the pre-set level which is adjustable between 40% RH & 95% RH. Complete with integral adjustable timer (adjustable 1-20 mins).
CF200HP As above but with pullcord override switch. Requires no switched live.
CF200PIR PIR activated model with adjustable timer which switches on as a person enters the room and runs on after the room is vacated. There is no need to connect to a separate switch. Timer adjustable between 1-20 mins. Requires no switched live.

Construction

The CF200 fans are moulded in impact resistant high gloss ABS thermoplastics for strength, durability and appearance. Fitted with a powerful backward curved centrifugal impeller. A spring operated non return flap is built into the discharge spigot to prevent backdraughts.

Electrical

220-240V ~ A.C. 50Hz ns . Single phase consuming 45 watts. These fans are double insulated and do not require an earth. All wiring must comply with current IEE regulations. A double pole isolating switch, having a contact separation of at least 3mm in all poles, must be used with a 3 amp fuse fitted. The fan should not be accessible to a person using either the shower or the bath and mounted a minimum of 1.8 metres from the floor.

Motor

Single phase induction motors with pre-oiled bearings fitted for a long maintenance free life and protected by an auto-reset thermal cut-out.

Guarantee

Two year no quibble guarantee.

Installation

All models are designed to be mounted on walls or ceilings and discharged through 100mm (4") diameter flexible or rigid pipes. Also suitable for use with the Manrose low profile flat channel ducting systems 100mm or 125mm ranges.

Performance

110m³hr, 31 litres per second.

Packaging

Boxed in cartons of 10 measuring 753mm x 283mm x 390mm and weighs 12kgs.

Additional Data

Maximum pressure: 120 p.a. Fan speed: 1400 r.p.m. Sound volume: 45.0 dB(A).